Berkel 823E-PLUS Operations Instructions download pdf (Page 8)

6 • 823E, 825E&A, 827E&A OWNER/OPERATOR M ANUAL

3. Slide Product Table back and forth holding on to the Product Table Handle. If there is any

rough operation or obstruction, shut off, unplug power cord and call your Berkel service-

man.

4. Turn the slicer ON and check for smooth knife rotation. Turn the slicer OFF.

 

1. Rotate the pusher out of the way of the product table. Place product to be sliced on the

product table. Position the pusher at the end of product. If the product you’re slicing is

long, place the pusher on top of the product. The pusher will feed the product toward the

knife after each slice.

2. Turn the slicer ON.

3. The thickness control knob allows you to vary the thickness of the slices from paper thin to

approximately

” thick. To make thinner slices, turn the thickness control knob to the

right. For thicker slices, turn the knob to the left.

4. A handle is provided on the product table to move it back and forth.

5. After each use of the slicer, turn the slicer OFF and the thickness control knob full right.

This places the gauge plate in the closed position and covers the knife edge.

WARNING

WHEN MOVING THE PRODUCT TABLE,GRASP

ONLY THE PRODUCT TABLE HANDLE.

 

1. Turn OFF the slicer, turn index knob fully to the right and unplug the power cord from the

receptacle.

2. Loosen sharpener lock knob and lift off the sharpener.

WARNING

ONLY USE THE PRODUCT TABLE HANDLE TO MOVE THE PRODUCT TABLE.

6 •

823E, 825E&A, 827E&A Ow n e r /Op e r a t O r Ma n u a l

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Berkel 823E-PLUS Operations Instructions Page 8