Berkel 823E-PLUS Operations Instructions download pdf (Page 13)

823E, 825E&A, 827E&A OWNER/OPERATOR M ANUAL • 1 1

4. Are all components held securely in place? A loose product table or pusher can cause

inconsistent slices.

Knife not sharpening

1. Are sharpening procedures being followed exactly as explained in this manual (page 10).

2. Are sharpening stones clean? If not, clean according to instructions given in “Sharpener

Maintenance” section (page 7).

3. Is the knife clean? If coated with food fats, sharpener stones cannot sharpen. Clean per

instructions (page 7).

4. Are sharpening stones making solid contact with the knife? If not, have your Berkel

serviceman adjust them to the proper height.

5. Are sharpening stones severely worn and not making contact with the knife? Are the

sharpening stones cracked or chipped? If so, have your Berkel serviceman replace and

adjust the new stones to the proper position for best sharpening results.

Electrical failure

1. Is slicer fully plugged into a properly grounded 120/AC outlet? If properly connected, the

red or white power on light should be on when switch is in the ON position.

2. Inspect power cord. Has it been damaged, cutting off electrical flow? If so, call your

Berkel serviceman to replace the power cord.

3. Is ON/OFF switch in the ON position?

4. Are you getting electricity from the wall outlet? Check by plugging in another piece of

equipment with the same electrical requirements. Also, check circuit breaker or fuse

5. If you are getting electrical power and your slicer is still not operating, contact your Berkel

serviceman.

Thickness control knob not operating gauge plate

1. If the thickness control knob is not opening and closing the gauge plate properly, it is a

sign that the internal mechanism has suffered some loss of adjustment. Do not try to adjust

the mechanism yourself. Call your Berkel Serviceman.

If correction of any of the above conditions does not result in a functional slicer, call your

Designated Berkel Service Location.

823E, 825E&A, 827E&A Ow n e r /Op e r a t O r Ma n u a l •

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Berkel 823E-PLUS Operations Instructions Page 13