Berkel 823E-PLUS Operations Instructions download pdf (Page 10)

8 • 823E, 825E&A, 827E&A OWNER/OPERATOR M ANUAL

5. Shake excess water out and pat partially dry with paper toweling or a clean cloth towel.

Set aside to air dry.

6. Once the stones are dry (after 24 hours), oil the shafts with Berkel Food Machine Oil.

7. Reassemble.

Berkel recommends that a spare set of stones (Berkel Part # 825-00112) be kept available for

thorough cleaning procedures, and in case of breakage, so you will not lose your sharpening

capabilities.

  

1. Turn slicer OFF and unplug the power cord.

2. Turn the thickness control knob all the way to the right to close the gauge plate.

3. Remove the product table locking knob.

4. Remove the product table.

5. Remove the slice deflector which is attached to the main slicer body.

6. Unscrew the center plate locking knob. Push on the knob to move the center plate off the

knife. Remove both the center plate and the locking knob.

7. Clean and sanitize removed parts. Wash these parts in hot water with detergent, rinse in hot

water and rinse again in sanitizing solution. Let the parts air dry. Berkel recommends using

USDA approved sanitizer, Berkel part number 4975-00400.

  

1. Switch slicer off and unplug the power cord.

2. Make sure thickness control knob is fully to the right, so the gauge plate covers the knife.

3. Clean front of knife, moving from center outward.

WARNING

THE PUSHER CAN SLIDE OR ROTATE, SO KEEP THE

PRODUCT TABLE LEVEL IN THE NEXT STEP.

8 •

823E, 825E&A, 827E&A Ow n e r /Op e r a t O r Ma n u a l

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Berkel 823E-PLUS Operations Instructions Page 10